Fabricate: Sketch Model Six

0 Comments
Sketch Model #6

This sketch model was to investigate the stacking method with the use of split pins. This was to see if many layers could fit on the same split pin, with the split pin as the center point. The result of this investigation was that quite a few layers could fit on a split pin, but the legs of the pin would become less supportive as more layers were put on.





About Post Author

Morbi leo risus, porta ac consectetur ac, vestibulum at eros. Fusce dapibus, tellus ac cursus commodo, tortor mauris condimentum nibh, ut fermentum massa justo sit amet risus.

You may also like

No comments:

Powered by Blogger.

About

I am a designer, currently studying Design Innovation at Victoria University of Wellington. My focus areas are website and mobile media development, interaction design, 3D modelling and animation and audio-visual space. My blog shows my journey through each project as well as my learning experience through university. What do I want to be when I grow up? I have no idea. But I love what I'm learning. Although there have been many bumps along the road in this journey and despite the fact that there are going to be many more, I wouldn't have it any other way.

Labels

Blog Archive